Still in the process of modeling the MPLS network that we currently have with one of our Service Providers.
At this point I have placed the same config on the Lab CE's that exist in our production network. I have also followed Cisco Documentation to configure the PE routers, however I cannot get the CE to PE BGP peering.
What am I missing?
***********
*CE Router*
***********
nterface Loopback0
ip address 10.18.0.8 255.255.255.255
!
interface FastEthernet0/0
ip address 68.139.201.30 255.255.255.252
duplex half
!
interface FastEthernet1/0
no ip address
shutdown
duplex half
!
interface FastEthernet1/1
no ip address
shutdown
duplex half
!
interface FastEthernet2/0
no ip address
duplex full
!
router bgp 1
no synchronization
bgp log-neighbor-changes
neighbor 68.139.201.29 remote-as 65000
***********
*PE Router*
***********
ip vrf vpn-mtb
rd 1:100
route-target export 1:100
route-target import 1:100
!
no ip domain lookup
mpls label protocol ldp
tag-switching tdp router-id Loopback0
!
!
!
!
interface Loopback0
ip address 68.2.0.1 255.255.255.252
!
interface FastEthernet0/0
ip address 68.2.1.2 255.255.255.252
duplex auto
speed auto
tag-switching ip
!
interface FastEthernet1/0
ip vrf forwarding vpn-mtb
ip address 68.139.201.29 255.255.255.252
duplex auto
speed auto
!
interface FastEthernet2/0
no ip address
shutdown
duplex auto
speed auto
!
router ospf 1
router-id 68.2.0.1
log-adjacency-changes
network 68.0.0.0 0.255.255.255 area 0
!
router bgp 65000
no synchronization
bgp log-neighbor-changes
redistribute connected
neighbor 68.2.0.3 remote-as 65000
neighbor 68.2.0.3 update-source Loopback0
no auto-summary
!
address-family vpnv4
neighbor 68.2.0.3 activate
neighbor 68.2.0.3 send-community extended
exit-address-family
!
address-family ipv4 vrf vpn-mtb
redistribute connected
neighbor 68.139.201.30 remote-as 1
neighbor 68.139.201.30 activate
neighbor 68.139.201.30 as-override
no auto-summary
no synchronization
exit-address-family
