Editing VPN Client MSI

Unanswered Question
Jan 6th, 2009


Does anyone have documentation on editing the VPN client setup MSI file to add company logos, ini and pcf files? The one located on the Cisco website isn't very helpful I find.

Thank You

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Mark Yeates Tue, 01/06/2009 - 13:30


I am not too sure about the company logos, but what I do is include the .pcf profiles with the installation. All you do is copy the .pcf file(s) if you have multiple profiles into the same folder as the installer. It will be copied to the correct location. This link may be the same one you were referring to but if not I hope it helps.



P.S. I believe the same goes for the setup ini file, but have never tested it before.

DialerString_2 Mon, 01/19/2009 - 07:47


Did you ever figure out how to accomplish this? I've been all over the net and Cisco.

sean-boston Mon, 01/19/2009 - 12:58

Hello DialerString;

No, I haven't figure it out. There is just no good documentation out there.


This Discussion