01-06-2009 11:44 AM
Hello;
Does anyone have documentation on editing the VPN client setup MSI file to add company logos, ini and pcf files? The one located on the Cisco website isn't very helpful I find.
Thank You
01-06-2009 01:30 PM
Sean,
I am not too sure about the company logos, but what I do is include the .pcf profiles with the installation. All you do is copy the .pcf file(s) if you have multiple profiles into the same folder as the installer. It will be copied to the correct location. This link may be the same one you were referring to but if not I hope it helps.
http://www.cisco.com/univercd/cc/td/doc/product/vpn/client/rel4_0/admin_gd/vcach5.htm#30347
Mark
P.S. I believe the same goes for the setup ini file, but have never tested it before.
01-19-2009 07:47 AM
Sean,
Did you ever figure out how to accomplish this? I've been all over the net and Cisco.
01-19-2009 12:58 PM
Hello DialerString;
No, I haven't figure it out. There is just no good documentation out there.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: