ASA EIGRP routing

Answered Question
Jan 7th, 2009

Hi,

I have an ASA5510 ver8.0(3), its running EIGRP. From the ASA all EIGRP routes/subnets are learned and are pingable. My issue is when I set my PC's default gateway to the ASA inside interface, I'm unable to reach any other subnets or eigrp routes that my ASA could reach.

Any suggestions?

Thanks.

I have this problem too.
0 votes
Correct Answer by Jon Marshall about 7 years 11 months ago

Fred

Are the other subnets reachable via the inside interface ? If so the ASA would need to send the traffic from your PC back out the inside interface and you need to set this up -

http://www.cisco.com/en/US/products/ps6120/products_tech_note09186a0080734db7.shtml

Other than that have you

1) checked that what you are trying to ping has routes back to your PC subnet

2) that you are allowing ICMP with access-lists on the relevant interfaces

Jon

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Correct Answer
Jon Marshall Wed, 01/07/2009 - 07:57

Fred

Are the other subnets reachable via the inside interface ? If so the ASA would need to send the traffic from your PC back out the inside interface and you need to set this up -

http://www.cisco.com/en/US/products/ps6120/products_tech_note09186a0080734db7.shtml

Other than that have you

1) checked that what you are trying to ping has routes back to your PC subnet

2) that you are allowing ICMP with access-lists on the relevant interfaces

Jon

Actions

This Discussion