01-07-2009 09:06 AM - edited 03-06-2019 03:17 AM
Hi All,
Iam planning to upgrade IOS on dual SupV 4510R to most recent 12.2.50-SG to support ip tracking feature for Internet reachability.
Current IOS: cat4000-i9s-mz.122-25.EWA4
The switch has BGP/OSPF/EIGRP protocols with SSO redundancy. In the 12.2.50 train, the naming convention for IOS is little different. Will
ENTERPRISE SERVICES W/O CRYPTO
cat4500-entservices-mz.122-50.SG.bin
OR
IP BASE W/O CRYPTO
cat4500-ipbase-mz.122-50.SG.bin
is recomended. My choice is 1st one, but would like to get openions from gurus. Also, upgrading IOS does not need SUP firmware upgrade. is that correct.?
Thank you in advance
MS
01-07-2009 09:23 AM
MS
You should use Feature Navigator to choose which IOS feature set you need. The IP Base will not have EIGRP/BGP/OSPF support - for that you need Enterprise Services -
http://tools.cisco.com/ITDIT/CFN/jsp/index.jsp
No, you should not have to upgrade the firmware.
Jon
01-07-2009 11:35 AM
Not sure ipbase would cover the advanced routing protocols , you would need enterprise services.
01-07-2009 12:27 PM
Thank you both. I will go with enterprise version. Also, for IOS upgrade with dual sups, Iam refering to the link
I need to run both the below commands (to upload IOS to Active & stdby sups)
Switch# copy source_device:source_filename
bootflash:target_filename
and
Switch# copy source_device:source_filename
slavebootflash:target_filename
I do not have to kill the redundancy to upload the IOS. Please clarify.
Thank you
MS
01-09-2009 08:03 AM
Hi,
Any suggestions..?
Thank you
MS
01-09-2009 09:01 AM
I do not have to kill the redundancy to upload the IOS. Please clarify.
>>>> Simply uploading an IOS to the bootflash of the standby will not kiil the redundancy.
I hope that answers your question.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide