01-07-2009 12:22 PM - edited 03-15-2019 03:22 PM
In my ccm6 and MGCP gateway if I disconnected the call from PSTN, the IP phone still ringing for about 15-20 seconds.
Any one please help where is such kind of parameter in Callmanager
01-07-2009 04:03 PM
If this is an FXO port, try 'no battery-reversal' on the voice-port config.
hth,
nick
01-08-2009 12:33 AM
ok
but this is an MGCP gateway.Is in MGCP gateway is controlled by callmanager?
Anyway I will try...
01-08-2009 06:47 AM
CCM will not control the analog telephony of the FXO, which is where it sounds like you may be having the problems. This is in contrast to a PRI where CCM controls the signaling on the PRI.
01-08-2009 02:05 PM
dear,
i apllied no battery reversal,but its again the same pblm.
I think there may be any service parameter in CCM.
Please suggest
01-08-2009 03:11 PM
I can't think of anything else off the top of my head. You could put a TAC case in to pull the traces and debugs.
-nick
04-06-2013 10:06 AM
Hi,
i have this problem too, can you solved it?
04-06-2013 12:23 PM
Hi
Did you check the below link
http://www.cisco.com/en/US/tech/tk652/tk653/technologies_tech_note09186a00800ae2d1.shtml
please try the below commands onyour gateway
voice-port 0/0/0
supervisory disconnect dualtone mid-call
cptone CN (CN is for your country)
timeouts interdigit 2
timeouts call-disconnect 1
timeouts wait-release 1
mgcp
mgcp bind control source interface fas0/0
mgcp bind media source interface fas0/0
no mgcp
mgcp
Thank you
please if this will help
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide