01-07-2009 12:22 PM - edited 03-15-2019 03:22 PM
In my ccm6 and MGCP gateway if I disconnected the call from PSTN, the IP phone still ringing for about 15-20 seconds.
Any one please help where is such kind of parameter in Callmanager
01-07-2009 04:03 PM
If this is an FXO port, try 'no battery-reversal' on the voice-port config.
hth,
nick
01-08-2009 12:33 AM
ok
but this is an MGCP gateway.Is in MGCP gateway is controlled by callmanager?
Anyway I will try...
01-08-2009 06:47 AM
CCM will not control the analog telephony of the FXO, which is where it sounds like you may be having the problems. This is in contrast to a PRI where CCM controls the signaling on the PRI.
01-08-2009 02:05 PM
dear,
i apllied no battery reversal,but its again the same pblm.
I think there may be any service parameter in CCM.
Please suggest
01-08-2009 03:11 PM
I can't think of anything else off the top of my head. You could put a TAC case in to pull the traces and debugs.
-nick
04-06-2013 10:06 AM
Hi,
i have this problem too, can you solved it?
04-06-2013 12:23 PM
Hi
Did you check the below link
http://www.cisco.com/en/US/tech/tk652/tk653/technologies_tech_note09186a00800ae2d1.shtml
please try the below commands onyour gateway
voice-port 0/0/0
supervisory disconnect dualtone mid-call
cptone CN (CN is for your country)
timeouts interdigit 2
timeouts call-disconnect 1
timeouts wait-release 1
mgcp
mgcp bind control source interface fas0/0
mgcp bind media source interface fas0/0
no mgcp
mgcp
Thank you
please if this will help
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: