Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
1215
Views
4
Helpful
3
Replies

1 Gbps Hub

Go to solution
narasimhanv
Level 1
Level 1

‎01-08-2009 02:15 AM - edited ‎03-06-2019 03:18 AM

I need to buy an 1 Gbps Hub. Can anyone suggest a Good Branded Hubs...

Labels:
0 Helpful
1 Accepted Solution

Accepted Solutions

Go to solution
Roberto Salazar
Level 8
Level 8
In response to narasimhanv

‎01-08-2009 09:45 PM

Sounds like a SPAN will do.

Local SPAN, RSPAN, and ERSPAN sessions allow you to monitor traffic on one or more ports, or one or more VLANs, and send the monitored traffic to one or more destination ports. With Release 12.2(18)SXD and later releases, you can configure per-VLAN filtering on destination trunk ports.

Here are more details in SPAN and how to configure it:

http://www.cisco.com/en/US/docs/switches/lan/catalyst6500/ios/12.2SXF/native/configuration/guide/span.html#wp1020356

View solution in original post

0 Helpful
3 Replies 3

Go to solution
Collin Clark
VIP Alumni
VIP Alumni

‎01-08-2009 06:30 AM

I doubt you'll find a hub, however there are 10/100/100 switches that a pretty cheap (unmanaged). Here's an example-

http://www.linksys.com/servlet/Satellite?c=L_Product_C2&childpagename=US%2FLayout&cid=1123638180556&pagename=Linksys%2FCommon%2FVisitorWrapper&lid=8055622279B04

Hope that helps.

Go to solution
narasimhanv
Level 1
Level 1
In response to Collin Clark

‎01-08-2009 09:38 PM

Hi,

My requirement is two nodes are connected like this below

MS--->BS..Actually i like to capture the packets between BS and MS..My requirement is i need to view the traces in two or more PC's.( i need to run Ethereal or Wireshark in those PC's and would like to capture the traces)..for the above case, can i use Switch?..( since the debugs are pumped in a very high rate, that is the reason why i asked about a 1 Gbps Hub)..if you let me know, how to achieve this using a switch, that would be of great help...

0 Helpful

Go to solution
Roberto Salazar
Level 8
Level 8
In response to narasimhanv

‎01-08-2009 09:45 PM

Sounds like a SPAN will do.

Local SPAN, RSPAN, and ERSPAN sessions allow you to monitor traffic on one or more ports, or one or more VLANs, and send the monitored traffic to one or more destination ports. With Release 12.2(18)SXD and later releases, you can configure per-VLAN filtering on destination trunk ports.

Here are more details in SPAN and how to configure it:

http://www.cisco.com/en/US/docs/switches/lan/catalyst6500/ios/12.2SXF/native/configuration/guide/span.html#wp1020356

0 Helpful
Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card