distribute-list out configuration

Unanswered Question
Jan 8th, 2009

Hi all,

need enlightenment, i try to configure "distribute-list out" to filter rip routing update. the goal is to access one destination(in this case Lopbck1 on router 1) from different source/segment through different link as well. my configuration as below (unfortunetly doesn't work)

-------------

on router 1

interface Loopback0

ip address 10.10.10.1 255.255.255.0

!

interface Serial0/2/0

ip address 192.168.0.1 255.255.255.252

!

interface Serial0/2/1

ip address 192.168.0.5 255.255.255.252

!

router rip

version 2

network 10.0.0.0

network 192.168.0.0

on router 2

interface Loopback0

ip address 20.20.20.1 255.255.255.0

!

interface Loopback1

ip address 40.10.10.1 255.255.255.0

!

interface Serial0/0/0

ip address 192.168.0.2 255.255.255.252

!

interface Serial0/0/1

ip address 192.168.0.6 255.255.255.252

!

router rip

version 2

network 20.0.0.0

network 40.0.0.0

network 192.168.0.0

distribute-list viaS0/0/0 out Serial0/0/0

distribute-list inboundany in Serial0/0/0

distribute-list viaS0/0/1 out Serial0/0/1

distribute-list inboundany in Serial0/0/1

!

ip access-list standard inboundany

permit any

!

ip access-list standard viaS0/0/0

permit 20.20.20.0 0.0.0.255

permit 192.168.0.0 0.0.0.2

deny any log

ip access-list standard viaS0/0/1

permit 40.10.10.0 0.0.0.255

permit 192.168.0.4 0.0.0.2

deny any log

check on access-list no packet match. appreciate your input

thanks

jimmy

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Richard Burts Thu, 01/08/2009 - 04:50

This same question is posted on the WAN Routing and Switching forum where it has received several good answers. I suggest that any further discussion of this be consolidated in the WAN forum.

HTH

Rick

mikegrous Thu, 01/08/2009 - 05:44

i ran into the same problem with named ACLS. i ended up using standard acls 1-99 and then it worked perfectly.

Actions

This Discussion