CatOS CLI equivalent of what Mini-RMON manager does

Answered Question
Jan 8th, 2009
User Badges:
  • Gold, 750 points or more

I assume the Mini-RMON manager in CiscoView is using snmpsets to configure the RMON on CatOS, but I haven't found any documentation on what exactly are getting set, except "set snmp rmon" and some of the possible MIB OIDs, unlike the aplentyful info on what can be done on IOS. I assume the RMON settings will be saved in the running-config in clear text. Such info would be come in handy, because Mini-RMON manager appears to be able to configure only one device at a time.


Correct Answer by Joe Clarke about 8 years 2 months ago

There is no CLI interface for mini-RMON in CatOS. Everything the CiscoView mini-RMON manager does is via SNMP using the RMON-MIB.


Here's a document illustrating how RMON events and alarms can be configured using SNMP:


http://www.cisco.com/en/US/tech/tk961/technologies_configuration_example09186a0080093e96.shtml


The same general principle applies to configuring stats and histories. You could also sniff the traffic the mini-RMON manager sends to the device to get an idea of how configuration is done.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Correct Answer
Joe Clarke Thu, 01/08/2009 - 12:59
User Badges:
  • Cisco Employee,
  • Hall of Fame,

    Founding Member

There is no CLI interface for mini-RMON in CatOS. Everything the CiscoView mini-RMON manager does is via SNMP using the RMON-MIB.


Here's a document illustrating how RMON events and alarms can be configured using SNMP:


http://www.cisco.com/en/US/tech/tk961/technologies_configuration_example09186a0080093e96.shtml


The same general principle applies to configuring stats and histories. You could also sniff the traffic the mini-RMON manager sends to the device to get an idea of how configuration is done.

Actions

This Discussion