01-08-2009 02:40 PM - edited 03-06-2019 03:20 AM
Hi Guys,
Please help to configure my norton ghost ony 3500 switch.
Thanks,
Jong
Solved! Go to Solution.
01-08-2009 03:45 PM
whatever your routed interface is (ie your default gateway) will probably need multicast turned on and ip pim sparse-dense mode enabled on the interface.
01-08-2009 02:48 PM
I believe Norton Ghost uses multicast in pushing images to the hosts, so in a nutshell enable ip multicast routing and enable pim on all L3 interfaces.
01-08-2009 03:19 PM
thanks for the info, i think my 3500xl switch doenst have ip multicast routing command. is there a way to use it for ghosting?
01-08-2009 03:22 PM
then just put both the ghost server and client in the same vlan, that should work. and yes, 3500xl is strictly a layer 2 device, I mistaknely assume that you were referring to 3550.
01-08-2009 03:30 PM
Ok ill try it.
Thank you very much.
01-08-2009 03:45 PM
whatever your routed interface is (ie your default gateway) will probably need multicast turned on and ip pim sparse-dense mode enabled on the interface.
01-14-2009 12:22 PM
thanks guys. its now working. Actually i just created a vlan and i removed the ip-adress and helper on the configuration and it works
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide