01-09-2009 02:13 AM - edited 03-04-2019 03:23 AM
Hello All
I have a Cisco 2811 with IOS
C2800nm-ipbase-mz.124-3i.bin
I installed HWIC 1CE1T1-PRIA Card on it but I can not see in the config.
I tried many cards and slots on the router but still can not see
Any idea?
Thx
Ersin
01-09-2009 02:24 AM
The Minimum IOS requirement for the above card is 12.4(11)XW4 or 12.4(20)T
Upgrade the IOS and check again
Narayan
01-09-2009 02:33 AM
I used the
c2800nm-ipbasek9-mz.124-20.YA1.bin
I can see the card during boot but not in the configuration ?????
01-09-2009 02:36 AM
Here is the line during boot
mart Init is enabled
smart init is sizing iomem
ID MEMORY_REQ TYPE
0003E7 0X00473800 C2811 Mainboard
000529 0X00164800 1 port channelized and PRI T1/E1 HWIC
0X000021B8 Onboard USB
0X002C29F0 public buffer pools
0X00211000 public particle pools
TOTAL: 0X00AADBA8
If any of the above Memory Requirements are
"UNKNOWN", you may be using an unsupported
configuration or there is a software problem and
system operation may be compromised.
Rounded IOMEM up to: 12Mb.
Using 4 percent iomem. [12Mb/256Mb]
Weird thing is even it is working and can bee seen in the config serial module is not here ???
01-09-2009 02:46 AM
Can you post a sh diag from your device
Narayan
01-09-2009 02:54 AM
I am booting with 12.4-20T1 I will post it in 5 mins
01-09-2009 03:08 AM
01-09-2009 03:12 AM
Good to know that the problem has solved
Narayan
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: