Testing VIC2-2FX S and VIC2-2FXO cards

Unanswered Question
Jan 9th, 2009

I want to setup two 2611XM routers with a

NM-HD-2VE ( 3 DSP), VIC2-2FXS, VIC2-2FXO cards.

Can I connect the FXS to the FXO ?

Do I need to have telephones with RJ11 Straight through cables connected to the ports of the VIC's.

Could you point me to somewhere where this scenario is addressed. ( Voice certification test lab diagrams...)

Thank you,

Tom

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Nicholas Matthews Fri, 01/09/2009 - 08:26

Hi Tom,

FXS will always connect to FXO. Consider your provider to be FXS, and analog phones to be FXO ports.

You should be able to use a normal telephone cable to connect between the FXO and FXS.

I don't know of any documents that specifically say anything for back to back FXS/FXO, because they are documented separately normally.

hth,

nick

sandeep.karwall Wed, 12/14/2011 - 03:07

Dear Experts

This is going to be my first implimentation of the Voice network and is turning out to be a nightmare.i have reffered all the configuration mannuals , books and videos but still not able to make calls across the MPLS network.Need help urgently to solve the issue.

Here is the senario

PSTN>>>FXO(Cisco2905)>>>>>MPLS Cloud<<<<<<<(Cisco2905)FXS>>>>>>>>Phone

here is the configuration i have done

<<<<<<<<<>>>>>>>>

!

voice-port 0/1/0

!

voice-port 0/1/1

connection plar 2201

!

voice-port 0/1/2

!

voice-port 0/1/3

!

!

!

mgcp profile default

!

!

dial-peer voice 998 voip

destination-pattern 22..

session target ipv4:192.168.220.1

dtmf-relay cisco-rtp

!

dial-peer voice 100 pots

destination-pattern 9............

port 0/1/1

!

on

<<<<<<<<>>>>>>.

!

voice-port 0/0/0

cptone ID

!

voice-port 0/0/1

cptone ID

!

!

!

mgcp profile default

!

!

dial-peer voice 220 pots

destination-pattern 2201

port 0/0/0

forward-digits all

!

dial-peer voice 221 pots

destination-pattern 2202

port 0/0/1

forward-digits all

!

dial-peer voice 110 voip

destination-pattern 9T

session target ipv4:192.168.0.1

dtmf-relay cisco-rtp

!

=====================================

Early response is much appriciated

REGARDS

SANDEEP

Actions

This Discussion