Port Console

Kinai2008 · ‎01-09-2009

Hi.

I am trying to connect to a Cisco 837 by the console port and the only thing that appear in the screen are strange symbols. I restarted the router one or two times and tried to connect the console port in another computer but it didn't work.

The configuration of the HyperTerminal is:

Bits per second: 9600

Data Bits: 8

Parity: No

Stop Bits: 1

Flow Control: No.

A last thing. I put in the console port the ADSL rj11 by a mistake. I don't know if there is any relation.

Thanks for your help.

Kinai.

John Blakley · ‎01-09-2009

Try turning flow control to auto and see what happens. You could also try a different cable (unless you know this one works), try different port speeds, etc.

HTH,

John

HTH, John *** Please rate all useful posts ***

glen.grant · ‎01-09-2009

The port speed is set as something other than 9600 , you are going to have to runn thru all the speeds in increments of 9600 until you get a readable output . Someone may have had to xmodem in a image and increased the console port speed. If you get it to work check the config register , should be 0x2102.