Unanswered Question
Jan 10th, 2009

On a 2960...what is the command to show if portfast is enable on the ports?

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
starmantwo Sat, 01/10/2009 - 19:04

thanks for reply but i know how to put a port on portfast...i just wanted to know if there was any sh commands to display ports in portfast. Rather than doing a sh run...

lejoe.thomas Sat, 01/10/2009 - 19:12


Sorry about that, no its just the show run to verify.


show spanning tree interface | in PortFast

Mark Yeates Sat, 01/10/2009 - 19:31

Hi Lejoe,

I thought of that at first, but doing that will only show lines spanning-tree portfast and nothing more. It will not indicate which ports it is configured on.


Mark Yeates Sat, 01/10/2009 - 19:14


You can use the "show spanning-tree interface faX/X detail" command. It will show portfast is enabled or disabled. I don't know of a command that will quickly display all the ports of a switch that are configured for portfast.




This Discussion