01-10-2009 06:54 PM - edited 03-06-2019 03:22 AM
On a 2960...what is the command to show if portfast is enable on the ports?
01-10-2009 06:57 PM
Hi
int interface-id
spanning-tree portfast
HTH
Lejoe
01-10-2009 07:04 PM
thanks for reply but i know how to put a port on portfast...i just wanted to know if there was any sh commands to display ports in portfast. Rather than doing a sh run...
01-10-2009 07:12 PM
Hi,
Sorry about that, no its just the show run to verify.
Edit|
show spanning tree interface | in PortFast
01-10-2009 07:31 PM
Hi Lejoe,
I thought of that at first, but doing that will only show lines spanning-tree portfast and nothing more. It will not indicate which ports it is configured on.
Mark
01-10-2009 07:14 PM
Jeff,
You can use the "show spanning-tree interface faX/X detail" command. It will show portfast is enabled or disabled. I don't know of a command that will quickly display all the ports of a switch that are configured for portfast.
HTH,
Mark
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: