×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

E1R2 - is inter-register signaling configuration necessary?

Unanswered Question
Jan 11th, 2009
User Badges:

Hi all,

Would like to know if inter-register signaling (such as R2-compelled, R2-non-compelled) necessary for a E1R2 configuration?


I would like to integrate Cisco 2811 with NEC Neax 2000 using E1R2.


Thanks.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Nicholas Matthews Sun, 01/11/2009 - 20:14
User Badges:
  • Red, 2250 points or more

It will be necessary, yes. There is information passed with the inter-register signaling that is required for call setup.


Here's a good document on E1 R2 theory:

http://www.cisco.com/en/US/tech/tk652/tk653/technologies_tech_note09186a00800943c2.shtml#topic2



Also there's the little problem that the Cisco IOS CLI requires the inter-register signaling type when you define the ds0-group.


Router(config-controller)#ds0-group 1 timeslots 1-15 type r2-digital ?

dtmf DTMF tone signaling

r2-compelled R2 Compelled Register Signaling

r2-non-compelled R2 Non Compelled Register Signaling

r2-semi-compelled R2 Semi Compelled Register Signaling



Some interop documents:

http://www.cisco.com/en/US/products/hw/routers/ps259/prod_troubleshooting_guide09186a0080142533.html


E1 R2 with NEC PBX using 3745:

http://www.cisco.com/en/US/docs/voice_ip_comm/cucme/pbx/interop/notes/246672r2.pdf




hth,

nick


boonchin.ng Sun, 01/11/2009 - 22:56
User Badges:

Hi Nick,


Thanks for the quick reply. Hope you don't mind me to ask another question,


Do you have any experience if two-stage dialing is supported over E1 R2 interface?


Thanks.

paolo bevilacqua Mon, 01/12/2009 - 08:41
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member

Two stages dialing will work on E1 R2 just like one stage works as well.

Actions

This Discussion