QoS Validation

Unanswered Question
Jan 12th, 2009

Hi,

I have a bandwidth policy setup on an interface to ensure it does not go above 45M.I'm working on a strategy to have this tested out and ensure it works.

My qtn is, given i have a couple of routers i can use to generate traffic. How can i send a large amount of traffic to this router to validate the QoS policy is working as it should.

Thanks for your inputs!

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 2 (1 ratings)
Loading.
cisco_lad2004 Mon, 01/12/2009 - 03:52

for accurate results, you need a traffic generator.

If your policy is pure rate limiting, it shoudl be enough to watch both interface stats / load as well as service policy offered rate.

HTH

Sam

Actions

This Discussion