configure access point AIR LAP1131-G-E-K9

Unanswered Question
Jan 12th, 2009

the LAP was reset to default using the mode button. It already has an lwapp image downloaded from the controller on it. I cannot reconfigure it with IP address and controller IP address. Command disabled message is obtained

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Leo Laohoo Tue, 01/13/2009 - 21:14

You can't configure an AP when it's on Lightweight mode. If you want to configure the IP Address it has to be on Autonomous mode.

Does this help with your question?

madhvigokool Tue, 01/13/2009 - 21:30

I uploaded an autonomous image on the AP but I do not get the lwapp ip addrress command so that I can configure a static Ip address on the device. Can you help me out?

Leo Laohoo Wed, 01/14/2009 - 15:08

Here's a silly question: Is the AP running the newly uploaded Autonomous IOS?

Lightweight IOS always have a "rcv" prefix in the filename.


This Discussion



Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode