01-12-2009 01:13 AM - edited 07-03-2021 04:58 PM
the LAP was reset to default using the mode button. It already has an lwapp image downloaded from the controller on it. I cannot reconfigure it with IP address and controller IP address. Command disabled message is obtained
01-13-2009 09:14 PM
You can't configure an AP when it's on Lightweight mode. If you want to configure the IP Address it has to be on Autonomous mode.
Does this help with your question?
01-13-2009 09:30 PM
I uploaded an autonomous image on the AP but I do not get the lwapp ip addrress command so that I can configure a static Ip address on the device. Can you help me out?
01-14-2009 03:08 PM
Here's a silly question: Is the AP running the newly uploaded Autonomous IOS?
Lightweight IOS always have a "rcv" prefix in the filename.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: