01-13-2009 06:22 AM - edited 03-06-2019 03:24 AM
Hi Guys,
How can I setup a sniffer in 3750 switch? I would like to monitor a specific port. Is there a command like monitor port like this?
Switch(config-if)#interface fastethernet 0/4
Switch(config-if)#port monitor fastethernet 0/3
Thanks in advance.
Cheers!
Solved! Go to Solution.
01-13-2009 06:38 AM
Here's an example of the commands to setup a SPAN port.
monitor session 1 source interface Gi10/21
monitor session 1 destination interface Gi11/2
Hope that helps.
01-13-2009 06:38 AM
Here's an example of the commands to setup a SPAN port.
monitor session 1 source interface Gi10/21
monitor session 1 destination interface Gi11/2
Hope that helps.
01-13-2009 07:07 AM
Thanks Collin. I will try this.
Cheers!
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: