cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
608
Views
5
Helpful
5
Replies

EIGRP update being received on all but 1 router

nancyrawls
Level 1
Level 1

Made an update to an access list (advertising a new subnet out all interfaces) and all but 1 router received the update. The configs look to be identical so not sure why this one router is not updating it's routing table. When you do "sh ip eigrp traffic" the router in question is getting updates, hellos, etc.. When I do "sh ip route x.x.x.x." the response back is "subnet not in table".

1 Accepted Solution

Accepted Solutions

Hello Nancy,

try to restart that specific EIGRP adjacency if it is on a dedicated link by shutting down and then up the link on the core side

Hope to help

Giuseppe

View solution in original post

5 Replies 5

Giuseppe Larosa
Hall of Fame
Hall of Fame

Hello Nancy,

verify if that specific router has a distribute-list inbound filtering the new subnet (for example allowing only the old ones)

Hope to help

Giuseppe

no such luck but thanks anyhow.

Hello Nancy,

try to restart that specific EIGRP adjacency if it is on a dedicated link by shutting down and then up the link on the core side

Hope to help

Giuseppe

That's what I was planning on doing - and sure enough - that fixed it! Thanks.

Rick Morris
Level 6
Level 6

Is it possible to post the config of the eigrp and acl/route-maps on the advertising router. and one working end point router and the router not receiving the route?

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: