01-14-2009 03:35 AM - edited 03-15-2019 03:30 PM
CallerID is displayed,
But Station ID is not, why?
Here is the config
voice-port 0/1/0
connection plar opx 0
description desc-1
station-id name st-1
station-id number 555
caller-id enable
01-14-2009 05:22 AM
IOS will try to get caller-id first, and then station id if caller-id fails.
This means you have a calller-id error.
Try using the correct cptone for your country?
-nick
01-14-2009 10:31 AM
I get Caller-ID
But at the same time, I want to see Station-ID
Thanks
01-14-2009 10:47 AM
We will only show one or the other.
This is the order the CME will choose Caller ID:
1) Caller ID (if it exists)
2) Station ID (if it exists)
3) Destination pattern on incoming pots dial peer
It's not possible to display both the caller id and station id. The station ID replaces the caller id if it does not exist.
hth,
nick
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: