FCC in Africa

Unanswered Question
Jan 14th, 2009

Hi Team

We have a small problem with the AP's for a University in Africa. The 53 Cisco 1252 Access points that were designed are FCC.

That means on the WiSM I can't change the country code to ZA because the AP then doesn't report in. If I change it to US then the AP's say “RADIO LOW POWER”.

any way to get this right

Thanx in advance

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
rob.huffman Wed, 01/14/2009 - 06:06

Hi Tau,

This error "Radio Low Power" usually indicates a problem with PoE or power injector config. What are you using for the 1252's?? If you are using an "E" Series 3750 this is a very good thread;

http://forum.cisco.com/eforum/servlet/NetProf?page=netprof&forum=Wireless%20-%20Mobility&topic=General&topicID=.ee6e8b8&fromOutline=&CommCmd=MB%3Fcmd%3Ddisplay_location%26location%3D.2cc039db

Hope this helps!

Rob

Actions

This Discussion

 

 

Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode