This command controls the following traps from the CISCO-CAT6K-CROSSBAR-MIB:
cc6kxbarIntBusCRCErrExcdNotif
cc6kxbarIntBusCRCErrRcvrdNotif
cc6kxbarSwBusStatusChangeNotif
The description of these objects is as follows:
cc6kxbarIntBusCRCErrExcdNotif NOTIFICATION-TYPE
OBJECTS {
entPhysicalName,
entPhysicalVendorType
}
STATUS current
DESCRIPTION
"A cc6kxbarIntBusCRCThreshExcdNotif notification
is sent by the system when the system has
detected that the internal bus CRC error on
a physical entity (such as a module) as specified
by entPhysicalName has exceeded the fatal threshold."
::= { ciscoCat6kXbarMIBNotifs 2 }
cc6kxbarIntBusCRCErrRcvrdNotif NOTIFICATION-TYPE
OBJECTS {
entPhysicalName,
entPhysicalVendorType
}
STATUS current
DESCRIPTION
"A cc6kxbarIntBusCRCErrRcvrdNotif notification
is sent by the system when the system has
recovered as the internal bus CRC error on
a physical entity (such as a module) as
specified by entPhysicalName has fallen below
the normal threshold."
::= { ciscoCat6kXbarMIBNotifs 3 }
cc6kxbarSwBusStatusChangeNotif NOTIFICATION-TYPE
OBJECTS {
cc6kxbarSwBusSwitchingStatus,
cc6kxbarSwBusFailureDuration
}
STATUS current
DESCRIPTION
"A cc6kxbarSwBusStatusChangeNotif notification
is sent by the the device when there is change
in switching status of the switching bus as
monitored by cc6kxbarSwBusSwitchingStatus."
::= { ciscoCat6kXbarMIBNotifs 1 }
