I have a 2610 router with a VWIC-2MFT-T1 card installed. The IOS is: c2600-jsx-mz.122-46a.bin
when I start the router, I see that the voice card is detected but then when I do a "show run" I do not see any voice port or interface etc. I can create dial-peer pots but I can not use any port command.
Do I need to run any special command to enable the router to see the voice card further? Do I need any additional module to install to support voice card?
The lines I see during start:
*Mar 1 00:00:05.028: %LINEPROTO-5-UPDOWN: Line protocol on Interface VoIP-Null0, changed state to up
*Mar 1 00:00:12.027: SERVICE_MODULE(Serial0/0): self test finished: PassedUnknown WIC in slot(0/1), wic card has an unknown id of 0x3FC