MPLS TE Tunnels configuration

Answered Question
Jan 14th, 2009

Hello.

I have the following doubt. What happens if I configure one TE tunnel in both ends. I have read that is enough configure only one side.

Thanks

I have this problem too.
0 votes
Correct Answer by gauravprakash about 7 years 10 months ago

The LSP starts on PE on which Tunnel was built and ends on some ther PE, and its unidirectional. To have bidirectional you need to make two Tunnels on each end.

HTH,

Gaurav Prakash

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Correct Answer
gauravprakash Thu, 01/15/2009 - 06:40

The LSP starts on PE on which Tunnel was built and ends on some ther PE, and its unidirectional. To have bidirectional you need to make two Tunnels on each end.

HTH,

Gaurav Prakash

Actions

This Discussion