ASA5520 SSH access

Unanswered Question
Jan 15th, 2009
User Badges:
  • Gold, 750 points or more

Dear all


I am adding a new jump station to the network which is supposed to connect via ssh only to ASA.

using ASDM, I add teh host address of jumpstation under properties, device access, secure shell and apply. easy enough, but does not work...any suggestions ?


TIA


Sam

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 3 (1 ratings)
Loading.
JORGE RODRIGUEZ Thu, 01/15/2009 - 04:41
User Badges:
  • Green, 3000 points or more

Sam, I assume you have configured crypto keys for ssh access as this is required for ssh access to security applience. If you have done so on this part I would then believe something wrong in your ssh added statement rule.


asa(config)#ssh < mask>


make sure ssh statement for jumpstation is comming from correct nameif interface.


examples

http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_configuration_example09186a008069bf1b.shtml


regards


cisco_lad2004 Thu, 01/15/2009 - 05:12
User Badges:
  • Gold, 750 points or more

Thanks for the response !

I found out teh config was correct, but DNS was point at wrong FW interface. and therfeore requests are dropped.


Sam

Actions

This Discussion