CTS/RTS and CTS-to-Self - How do I know what my cell is running?

Unanswered Question
Jan 15th, 2009

Hey all :)

So, I am doing some thruput testng on my wlans, and am getting approx 15M/bit thruput, just using iperf as a bandwdith tool.

Is this quite respectible?

So, looking at the following Cisco document


I can ONLY assume that my mixed mode cell is running CTS-to-self.

How can I verify that the cell is operating in this mode?

Using a WLC, can you configure the use of RTS/CTS and CTS-to-Self?

Many thx indeed,


I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
bjohnson5@partn... Sun, 01/18/2009 - 16:07

Hey K,

Its my understanding (Cisco AS) that the controllers implement RTS/CTS. Probably due to the original 802.11b standard. Can anyone else confirm or deny this?

Bruce Johnson


This Discussion


Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode