cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
4541
Views
0
Helpful
2
Replies

CTS/RTS and CTS-to-Self - How do I know what my cell is running?

kfarrington
Level 3
Level 3

Hey all

So, I am doing some thruput testng on my wlans, and am getting approx 15M/bit thruput, just using iperf as a bandwdith tool.

Is this quite respectible?

So, looking at the following Cisco document

http://www.cisco.com/en/US/products/hw/wireless/ps4570/products_white_paper09186a00801d61a3.shtml

I can ONLY assume that my mixed mode cell is running CTS-to-self.

How can I verify that the cell is operating in this mode?

Using a WLC, can you configure the use of RTS/CTS and CTS-to-Self?

Many thx indeed,

Ken

2 Replies 2

wififofum
Level 4
Level 4

Hey K,

Its my understanding (Cisco AS) that the controllers implement RTS/CTS. Probably due to the original 802.11b standard. Can anyone else confirm or deny this?

Bruce Johnson

Thx Mate, I will look into this my side. also.

I will get back

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: