stcapp uc520 uc500 and mac address

Answered Question
Jan 15th, 2009
User Badges:

Hello everybody,

I would like to use the 4 FXS port of my UC500 as normale ephone using stcapp.

Where can I find the mac address to configure into the ephone statement relevant to the FXS port?


Thank you very much

Johnny


Correct Answer by Nicholas Matthews about 8 years 4 months ago

Hi,


You move the Chassis MAC over three digits, and then add the voice-port number. 0/0/1 becomes 001, etc.


Here's a guide on it:

http://www.cisco.com/en/US/docs/routers/access/vg202_vg204/software/vg2_vg4_voip_ps2250_TSD_Products_Configuration_Guide_Chapter.html#wp1059863


hth,

nick

Correct Answer by paolo bevilacqua about 8 years 4 months ago

Similarly to your ATA case, enable auto registration and observe which mac are actually presented. The next available ephone tag will be used, you the place the correct mac under it.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (2 ratings)
Loading.
Nicholas Matthews Thu, 01/15/2009 - 09:41
User Badges:
  • Red, 2250 points or more

From my UC520:


nicmatth-sip(config)#do sh diag | I Chassis MAC

Chassis MAC Address : 001d.45b9.6980



hth,

nick

l.buschi Thu, 01/15/2009 - 14:48
User Badges:

I need 4 mac address, one for each voice port in order to set it into any ephone

I think there should be a way to know them.

otherwise how can I configure my ephone referred to the voice ports?

Correct Answer
paolo bevilacqua Thu, 01/15/2009 - 17:15
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member

Similarly to your ATA case, enable auto registration and observe which mac are actually presented. The next available ephone tag will be used, you the place the correct mac under it.

Actions

This Discussion