01-15-2009 08:40 AM - edited 03-15-2019 03:32 PM
Hello everybody,
I would like to use the 4 FXS port of my UC500 as normale ephone using stcapp.
Where can I find the mac address to configure into the ephone statement relevant to the FXS port?
Thank you very much
Johnny
Solved! Go to Solution.
01-15-2009 05:15 PM
Similarly to your ATA case, enable auto registration and observe which mac are actually presented. The next available ephone tag will be used, you the place the correct mac under it.
01-15-2009 05:16 PM
Hi,
You move the Chassis MAC over three digits, and then add the voice-port number. 0/0/1 becomes 001, etc.
Here's a guide on it:
hth,
nick
01-15-2009 09:41 AM
From my UC520:
nicmatth-sip(config)#do sh diag | I Chassis MAC
Chassis MAC Address : 001d.45b9.6980
hth,
nick
01-15-2009 02:48 PM
I need 4 mac address, one for each voice port in order to set it into any ephone
I think there should be a way to know them.
otherwise how can I configure my ephone referred to the voice ports?
01-15-2009 05:15 PM
Similarly to your ATA case, enable auto registration and observe which mac are actually presented. The next available ephone tag will be used, you the place the correct mac under it.
01-15-2009 05:16 PM
Hi,
You move the Chassis MAC over three digits, and then add the voice-port number. 0/0/1 becomes 001, etc.
Here's a guide on it:
hth,
nick
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide