01-15-2009 12:24 PM - edited 03-06-2019 03:28 AM
hey all, we have two switches currently in a stack with one as master and other member. we'll be adding a third switch. all are identical models with same ios. the more i read the release notes, the more confused i get! anyway, here's our plan.
config from current switch:
switch 1 provision ws-c3750g-24ts
switch 2 provision ws-c3750g-24ts
new switch, member2, will be powered down and with the default configuration (no config added at all).
1. disconnect cable from "stack 2" master and "stack 1" member1.
2. connect cable from "stack 1" member1 to "stack 2" member 2.
3. connect stack cable from "stack 1" member2 to "stack 2" master
4. power up member2
am i missing anything else?
thanks a lot!
01-15-2009 01:13 PM
Robert,
It appears that you have the correct procedures. Hopefully this link will also help you understand the process.
HTH,
Mark
01-15-2009 01:24 PM
I'm going to add the following command on the stack master. Is there anything we have to do on the new switch that will be added? I have left it default.
switch 3 provision ws-c3750g-24ts
01-15-2009 01:37 PM
That will be fine as long as you are stacking it 3rd in the stack.
switch 1 provision ws-c3750g-24ts
switch 2 provision ws-c3750g-24ts
switch 3 provision ws-c3750g-24ts
HTH,
Mark
01-15-2009 02:03 PM
I also forgot to note to make sure you have a backup copy of the config.... Just in case.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: