Good Day,
I am setting up a 4402 (50 ap license ver 5.0) that will manage about 40 aps. Following the Cisco docs, I have created two ap manager intefaces for load balancing. Each physical port is attached to one of two Cat 6509s (no lag).
Our network ultimately connects to a router (over which I have no control) with six 100 mps ports each representing a subnet/vlan. So my intent is to create six dynamic interfaces each coresponding to a vlan for load balancing and bandwidth optimization.
My question regards assinging each dynamic interface to a physical port. Simple logic would have me assinging 3 interfaces to port #1 and three to port #2, then assigning a proportionate number of aps to each interface.
Is it that simple, or are there other considerations.
Thanks