Giving access to privilege mode or giving access to few commands

Answered Question
Jan 16th, 2009

We have a site to site vpn tunnel for different offices and we usually use taacs for username and password and we want to give privilege level access to few people. and access to only few commands in privilege mode using the same tacacs password ,, through cli and asdm?

Can you kindly help me with this

Thnx much

I have this problem too.
0 votes
Correct Answer by Jagdeep Gambhir about 7 years 10 months ago

Please check this link,

http://www.cisco.com/en/US/products/sw/secursw/ps2086/products_configuration_example09186a00808d9138.shtml

You need to setup command authorization.

Regards,

~JG

Do rate helpful posts

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
chandu.84 Fri, 01/16/2009 - 08:57

Kewl... Thnx a lot ,,, i did not check it ,, will do it now ,, but it looks that it will work,,,, Thnx a lot ,, gambhir,, much appreciated

Actions

This Discussion