Bus Asic #1 transient Pb error

Unanswered Question
Jan 17th, 2009
User Badges:

Error was seen from CISCO6506.

%PM_SCP-SP-2-LCP_FW_ERR_INFORM: Module 2 is experiencing the following error: Bus Asic #1 transient Pb error. Recovered. (0x0002, 0x0000)

Module 2 is WS-X6148-GE-TX

But all ports and protocols are running well all the time. Should I ignore this error?

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
johnlloyd_13 Sun, 01/18/2009 - 00:40
User Badges:
  • Blue, 1500 points or more

no, it's not just an informational syslog. according to cisco.com's error message decoder tool:


%PM_SCP-2-LCP_FW_ERR_INFORM:

Module [dec] is experiencing the following error: [chars]


An error condition was detected by the line card firmware and the supervisor is being informed about it.


Recommended Action: Copy the message exactly as it appears on the console or in the system log. Research and attempt to resolve the issue using the tools and utilities provided at

http://www.cisco.com/tac. With some messages, these tools and utilities will supply clarifying information. Also perform a search of the Bug Toolkit

http://www.cisco.com/pcgi-bin/Support/Bugtool/home.pl. If you still require assistance, open a case with the Technical Assistance Center via the Internet

http://tools.cisco.com/ServiceRequestTool/create, or contact your Cisco technical support representative and provide the representative with the gathered information.


Related documents- No specific documents apply to this error message.



in other words, try to open a cisco tac case to further troubleshoot.

Actions

This Discussion