Discovering Devices on the network using LMS 3.1

Unanswered Question

I have Ciscoworks 3.1 and have recently initiated the Device dicovery using the ping modules and a single seed device.

after the discovery process is completed, it discovers about 21 devices but only the seed device is reachable all others are unreachable and they all have the same snmp string.

how do i resolve this.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Joe Clarke Sun, 01/18/2009 - 20:44
User Badges:
  • Cisco Employee,
  • Hall of Fame,

    Founding Member

Assuming that you have set a range under the Discovery SNMP Settings that covers not only the seed device, but these other 21 devices, then check that there is not a firewall between the server and these devices which is blocking SNMP.


This Discussion