cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
343
Views
5
Helpful
3
Replies

Enable Auto-Registration During Business Hours?

jvweigand
Level 1
Level 1

We're getting ready to enable Auto-Registration on our CCM5.1.3 system. Is there any reason to not setup/enable it during business hours? I realize it'll cause a bit of a CPU/Network bandwidth hit when the phones start to register, but anything else beyond that?

Thanks in advance!

1 Accepted Solution

Accepted Solutions

ok, then that discards overlapping. so the only chance that someone could dial it without knowing the number would be by mistake. if you don't think anyone could end up dialing one of the new numbers by mistake then you can use the existing partition/CSS

HTH

java

if this helps, please rate

HTH

java

if this helps, please rate

View solution in original post

3 Replies 3

Jaime Valencia
Cisco Employee
Cisco Employee

only make sure that at that time the phones are auto-registered in a partition still not available to regular users and no overlapping to avoid calling issues

HTH

java

if this helps, please rate

HTH

java

if this helps, please rate

The DN range we're going to use for it isn't used anywhere else, should we still have it blocked off? Or with no potential for overlap, could we use an existing partition/CSS?

ok, then that discards overlapping. so the only chance that someone could dial it without knowing the number would be by mistake. if you don't think anyone could end up dialing one of the new numbers by mistake then you can use the existing partition/CSS

HTH

java

if this helps, please rate

HTH

java

if this helps, please rate
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: