01-19-2009 11:46 PM - edited 03-06-2019 03:32 AM
Some one please help!
i was following this guide on how to transfer IOS images to a router.
Around the part where i changed the baud rate to 115200 The Tera Term which i use to connect to the router stopped working,
even the guides instructions to enter the new baud rate configuration doesnt work.
Can any one please tell me how i can make Tera Term see the router again?
01-20-2009 04:20 AM
You changed the router to 115200 , did you then change tera term to 115200 , 8,n,1 so that they matched? You won't see anything if tera term was left at 9600 .
01-20-2009 04:54 AM
Woot! omg im finally in ~_~.
Yes, i changed Tera Term to 115200/8-n-1-hardware but it didnt work until i turned the router OFF/ON then Tera Term saw it! *phew*
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: