01-20-2009 04:59 AM - edited 03-06-2019 03:32 AM
Hello,
I want to Translate all my internal addresses on my WAN cisco's address.
I have followed NAT overload configuration sample in Cisco documentation, but that doesn't work.
No translations are perfomed for my internal adresses.
Could you help me ?
01-20-2009 05:28 AM
Hello there,
It looks like you need to add the IP nat outside and IP nat inside commands to the relevant interfaces...
interface vlan 1
ip nat inside
interface fa0/4
ip nat outside
Give that a try and see what happens...
Cheers
JOnathan
01-20-2009 05:41 AM
01-20-2009 06:46 AM
Your config should work but try this as well:
ip nat pool test 192.168.2.8 192.168.2.8 netmask 255.255.0.0
no ip nat inside source list 100 interface FastEthernet4 overload
ip nat inside source list 100 pool test overload
regards,
01-20-2009 07:37 AM
That doesn't work too
But with "no ip cef" in configuration that's work (eiter with interface overload or pool overload) !!!
Why ?
01-20-2009 05:35 AM
Hi Garnier,
Please add the following
You need specify nat inside and nat outside interfaces.
int fastethernet4
ip nat outside
int vlan1
ip nat inside
HTH
Lejoe
01-20-2009 05:36 AM
try put "ip nat outside" on WAN interface, and "ip nat inside" on LAN interface...
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide