01-20-2009 04:59 AM - edited 03-06-2019 03:32 AM
Hello,
I want to Translate all my internal addresses on my WAN cisco's address.
I have followed NAT overload configuration sample in Cisco documentation, but that doesn't work.
No translations are perfomed for my internal adresses.
Could you help me ?
01-20-2009 05:28 AM
Hello there,
It looks like you need to add the IP nat outside and IP nat inside commands to the relevant interfaces...
interface vlan 1
ip nat inside
interface fa0/4
ip nat outside
Give that a try and see what happens...
Cheers
JOnathan
01-20-2009 05:41 AM
01-20-2009 06:46 AM
Your config should work but try this as well:
ip nat pool test 192.168.2.8 192.168.2.8 netmask 255.255.0.0
no ip nat inside source list 100 interface FastEthernet4 overload
ip nat inside source list 100 pool test overload
regards,
01-20-2009 07:37 AM
That doesn't work too
But with "no ip cef" in configuration that's work (eiter with interface overload or pool overload) !!!
Why ?
01-20-2009 05:35 AM
Hi Garnier,
Please add the following
You need specify nat inside and nat outside interfaces.
int fastethernet4
ip nat outside
int vlan1
ip nat inside
HTH
Lejoe
01-20-2009 05:36 AM
try put "ip nat outside" on WAN interface, and "ip nat inside" on LAN interface...
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: