convert VSS in mode standalone

Unanswered Question
Jan 22nd, 2009


I need to undo a VSS and i have a doubt about the process, somebody has did it this before?

if I run:

1 .- in current active switch (switch1)

convert standalone mode switch

configuration related VSL and modules related to the switch 2 is deleted?

2.-record the configuration and restart the device (switch 1).

3 .- chassis standby (switch2) becomes active. I recover the Console so I can run:

convert standalone mode switch

4.- wr and reload switch2

5.-Once I have the two devices in standalone mode , just I have to execute: accept mode virtual switch?

or I have to re-configure the Switch ID switch domain, priorities ... in two devices ?

I need to pass over all process to convert two standalone devices in VSS:

convert virtual switch mode and finally switch accept mode virtual


I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)


This Discussion