I have IP SLA (Cat3560 with c3560-ipservicesk9-mz.122-46.SE) working with Ciscowork IPM (v2.6.0). I usually configured IP SLA from Ciscowork and it get to push to source device. However, I experience two issue and not able to find any solutions for it. Perhaps it is by default but just want to confirm it.
1. When I configured IP SLA from Ciscowork it get pushed to Cat 3560 and I am able to retrieve statistic and real time graphic fine. However, Ciscowork will not add collector into IPM if I CLI enter the IP sla commands in the switch. Are there anyway IPM will pickups the CLI collector in the switch and have those nice graph?
2. I am able to add Cisco SAA Responder in Targets just fine, and IPM is showing green light. I am able to add collectors from Source and target to Cisco SAA Responder and it shows historical statistics too. However when I want to check responder by type show ip sla responder it return with 0 controller message.
slaresponder#show ip sla responder
IP SLAs Responder is: Enabled
Number of control message received: 0 Number of errors: 0
Recent error sources:
Any suggestions or opinions are greatly appreciated!
Control messages are used for jitter. UDP echo is a basic echo (very much like ping). In fact, you don't need the responder to do a UDP or TCP echo. Just enable service udp-small-servers or tcp-small-servers, and you will have the echo service running. Both work the same way. What ever you send to the echo port gets replayed back to you.