01-23-2009 12:51 AM - edited 03-09-2019 09:58 PM
Hello,
I would like to bind my users to switchports. I could use port-security sticky but the administrative overhead seems very high. Has some experience with any third party or Cisco program which make it easier to mange it?
Another solution can be using 802.1x for user authentication and telling the switch not only the user vlan but the switchport. I am still looking for it, but have not found any RADIUS attrib for the switchport yet.
01-25-2009 04:09 AM
you can try some NAC solution, may be FreeNAC
01-26-2009 12:10 AM
Thanks!
01-27-2009 12:43 PM
VMPS will work as well, I tried it in a lab, it does the job but could be a bit messy to setup.
01-29-2009 12:01 AM
Thanks, I looked the web and found open-source VMPS servers (e.g: Icarus). It may be necessary to fine tune the code but seems ok.
01-29-2009 07:11 AM
I compiled the VMPS code without making any changes and it works just fine. You can also find Cisco documents online to assist you with the configuration of VMPS on the switches.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: