test etherchannel load-balance on 4948

Answered Question
Jan 23rd, 2009

is there a way to see where the traffic will go on cat 4948 in the etherchannel.

i could not find test etherchannel load-balance command.

I have this problem too.
0 votes
Correct Answer by Roberto Salazar about 7 years 10 months ago

Hi, here is what you are looking:

show platform software etherchannel port-channel 1 map x.x.x.x y.y.y.y

Switch#show platform software etherchannel port-channel 1 ?

map Map given parameters to a port in the channel

| Output modifiers

Switch#show platform software etherchannel port-channel 1 map ?

ip Ip address

l4-port TCP/UDP port numbers

mac Mac address

Switch#show platform software etherchannel port-channel 1 map 1.1.1.1 ?

% Unrecognized command

Switch#show platform software etherchannel port-channel 1 map ip ?

A.B.C.D Source/Destination Ip address

Switch#show platform software etherchannel port-channel 1 map ip

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (2 ratings)
Loading.
Correct Answer
Roberto Salazar Fri, 01/23/2009 - 11:54

Hi, here is what you are looking:

show platform software etherchannel port-channel 1 map x.x.x.x y.y.y.y

Switch#show platform software etherchannel port-channel 1 ?

map Map given parameters to a port in the channel

| Output modifiers

Switch#show platform software etherchannel port-channel 1 map ?

ip Ip address

l4-port TCP/UDP port numbers

mac Mac address

Switch#show platform software etherchannel port-channel 1 map 1.1.1.1 ?

% Unrecognized command

Switch#show platform software etherchannel port-channel 1 map ip ?

A.B.C.D Source/Destination Ip address

Switch#show platform software etherchannel port-channel 1 map ip

Actions

This Discussion