01-23-2009 10:36 AM - edited 03-06-2019 03:37 AM
is there a way to see where the traffic will go on cat 4948 in the etherchannel.
i could not find test etherchannel load-balance command.
Solved! Go to Solution.
01-23-2009 11:54 AM
Hi, here is what you are looking:
show platform software etherchannel port-channel 1 map x.x.x.x y.y.y.y
Switch#show platform software etherchannel port-channel 1 ?
map Map given parameters to a port in the channel
| Output modifiers
Switch#show platform software etherchannel port-channel 1 map ?
ip Ip address
l4-port TCP/UDP port numbers
mac Mac address
Switch#show platform software etherchannel port-channel 1 map 1.1.1.1 ?
% Unrecognized command
Switch#show platform software etherchannel port-channel 1 map ip ?
A.B.C.D Source/Destination Ip address
Switch#show platform software etherchannel port-channel 1 map ip
01-23-2009 11:54 AM
Hi, here is what you are looking:
show platform software etherchannel port-channel 1 map x.x.x.x y.y.y.y
Switch#show platform software etherchannel port-channel 1 ?
map Map given parameters to a port in the channel
| Output modifiers
Switch#show platform software etherchannel port-channel 1 map ?
ip Ip address
l4-port TCP/UDP port numbers
mac Mac address
Switch#show platform software etherchannel port-channel 1 map 1.1.1.1 ?
% Unrecognized command
Switch#show platform software etherchannel port-channel 1 map ip ?
A.B.C.D Source/Destination Ip address
Switch#show platform software etherchannel port-channel 1 map ip
01-23-2009 12:04 PM
awesome
you are the man
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: