hi every body!
Is there any command to setting the hold down timer on backup router in vrrp?
thanks a lot!
It roughly (advertisement int x 3) + 0.6 secs
eg: if the interval is 2 secs, holdtime is approx 6.6 secs .
You can see this in the example here.
For example, if i configure the vrrp advertisement interval to be 2 sec, it will set the master-down timer to 6 seconds. Is it correct?
You won't find much documentation within Cisco for VRRP for obvious reasons, thus I'm going to refer you to a third party book:
In short, the VRRP hold down timer is not configurable and it equals 3 times to advertisement interval.