Hi, I have to setup new V-lans department wise in our office. In current scenario, we have unmanaged switch which is connected with ASA 5505 FW where V-LAN 100 (NOC) is created and IP address of Inside Interface NOC V-lan is 192.168.12.1 which is a gateway set on client machines and Servers. This Network is connected with Remote sites via STS Tunnel. Now we want to make a new V-lans on new L2 switch and put the access list according to rights of users.
Here, I am bit confused about understanding new V-Lans structure. I want that the IT department and the Servers are remained in the NOC V-lan but would like to make seperate V-Lans for DEV and QA Team. I have created three following V-lans on L2 switch:
1) Vlan 100 NOC Port assigned eth 1-4
2) Vlan 200 DEV Port assigned eth 5-8
3) Vlan 300 QA Port assigned eth 9-12
Now I want to connect ASA Inside NOC Vlan 100 with the port 1 L2 switch where already same V-lan created but when I connect switch and FW and connect my laptop on port 2 of L2 switch then I am not able to ping the Inside Interface IP 192.168.12.1. Not able to underst
and where I am wrong. Second, I want to make a Trunk port on L2 switch on port 14 and connect with FW port 8 which is not a member of V-lan and want to do all settings on FW Trunk port like nattig, access list or etc. Please advice your suggestions in this regard. Can you please recommend how many network design I can use, Pl suggest as well if possible.