PIX 501 setting factory default

Unanswered Question
Jan 24th, 2009
User Badges:

What is the command for setting a PIX 501 to factory default settings, Version 6.2(2)?

The following command does not work.

pixfirewall(config)# configure factory-default 192.168.1.1 255.255.255.255

Specified IP address (192.168.1.1) is not allowed; it's a broadcast address.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
JORGE RODRIGUEZ Sat, 01/24/2009 - 17:33
User Badges:
  • Green, 3000 points or more

if you are using /24 network command syntax should be:


configure factory-default 192.168.1.1 255.255.255.0


or you can do configure factory-default command alone and it will use 192.168.1.1 255.255.255.0 for your inside interface and automatically create DHCPD pool for you on inside interface.


http://www.cisco.com/en/US/docs/security/pix/pix62/command/reference/c.html#wp1055799


Regards



saidfrh18 Sat, 01/24/2009 - 19:15
User Badges:

Jorge,

Neither command seem to work.


pixfirewall(config)# configure factory-default

.

Cannot select private keyWarning: Start and End addresses overlap with broadcast

address.

outside interface address added to PAT pool


pixfirewall(config)# configure factory-default 192.168.1.1 255.255.255.0

Warning: Start and End addresses overlap with broadcast address.

outside interface address added to PAT pool

JORGE RODRIGUEZ Sat, 01/24/2009 - 19:44
User Badges:
  • Green, 3000 points or more

never seen that before, use a different network address for sake of erasing the config, try 172.16.1.1 255.255.255.0 if success then do it for 192.168.1.1 /24 if not joy you may need to do write erase .


I assume you are doing it from local console


let me know if it worked out

Actions

This Discussion