RME 4.1.1 Syslog service Hung aft running well for a few hours

Unanswered Question
Jan 25th, 2009

Hi Experts,

I have a problem with Syslog Service it hung aft running for a few hours. I have restarted the service using CLI command net stop/start crmlog. It works fine for the first few hours and hung later. The number of syslog messages appeared to be the same when it hung.

Pls advise. Thanks!!

Regards

Yi Shyuan

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Joe Clarke Sun, 01/25/2009 - 11:46

There's nothing out of the ordinary here. there are some additional debugging steps which will need to be performed when the problem is occurring. These involve increasing the debug level, and capturing a full thread dump. Neither are particularly straight-forward. Go ahead and open a TAC service request, so that they can assist you when the problem occurs again.

Actions

This Discussion